FIXING a Broken Starlink (I HOPE) – I think I voided my warranty in the last video – Sorry SpaceX!

I think I VOIDED my WARRANTY! I BROKE my Rectangle Starlink, but with a bit of heat and solder – IT’S ALIVE!

Making an ULTRA Low Profile Starlink User Terminal comes with risks, but it is worth it for this SLEEK unit.

Some of the measurement values didn’t render in the video properly so I’ll link to the finished 3D model once complete.

If you’re thinking about doing a similar “opening”, the wall-thickness is 5mm and I would set the height of the cutter 8mm above the face of the dish.

References:
Main Power Supply:
Secondary Power Supply: https://www.monolithicpower.com/en/documentview/productdocument/index/version/2/document_type/Datasheet/lang/en/sku/MP8795HGLE-Z/document_id/9123/

Contents:
0:00 Building the ULTIMATE Mobile Starlink Panel
0:59 The Starlink Flat Panel So Far
2:34 Oh, I just BROKE my Starlink Unit 🙁
3:31 Starlink Ethernet Connector
4:23 A Tour of the INSIDE of a Starlink Dish
6:09 A Look at THE DAMAGE in my Starlink Dish
6:24 REPAIRING a Broken Starlink Dish
8:20 IT’S DONE!
8:33 MY STARLINK IS ALIVE!!!
9:38 Measuring the Inside of Starlink
13:18 Starlink SPEED TESTS and NEXT STEPS

#Starlink #SpaceX #Teardown