Wired
Earlier, there were rumors about OPPO’s new mid-to-high-end Reno6 product, and it was discovered by domestic media earlier that it had officially registered on the website of the Ministry of Industry and Information Technology, and had more detailed specifications and information outflow.
Refer to the Reno6/Reno6 Pro product photos published on the Tena website of the Ministry of Industry and Information Technology. It can be seen that the appearance of the mobile phone follows the design of the previous generation Reno5 series. Among them, the Reno6 continues the simple shape of the previous generation and is equipped with a straight three-camera module (below).
The Reno6 Pro even uses the 3+1 four-lens specification (the first picture), and the flash is moved to the vertical lower right corner of the module. On the front part, the Reno 6 Pro screen adopts a perforated screen design on the upper left, and from the announcement of the size of the button group on the right side of the fuselage, it is inferred that the device should continue to use the on-screen fingerprint recognition solution.
For the body specifications, according to the information published on the website of the Ministry of Industry and Information Technology, both Reno6 and Reno6 Pro will use a 6.55-inch 90Hz refresh rate of 2,400 x 1,080 resolution OLED open-hole screens, built-in dual cells to form an equivalent 4,500mAh battery and support 65W flash charging. The computing part is the same as the information circulating earlier. The Reno6 with a body size of 160 x 73.1 x 7.6mm will be equipped with Dimensity 1200 5G SoC; and the Reno6 Pro with a size of 160.8 x 72.5 x 7.99 mm will use Qualcomm Snapdragon. 870 5G SoC.
Source: Zhongguancun Online, Weibo