Elekworld
We had a repairing video about how to fix the problem of Face ID set up failure by grinding the metal shield on the Face ID module before, but some fans left comments that grinding method would leave obvious traces on Face ID module, which is not good for repair shop recycling. Now we will solve this problem by using hot air gun and updated JC V1S machine.
00:00 Intro
00:09 Tools we need
00:14 Base information of phone
00:34 Take apart the screen
00:50 Detach Face ID flex
01:09 Use JCV1S & Dot Projector Test Board to test
1:26 Copy data
1:43 Take down the disk
2:57 Install the old disk to the new flex
3:16 Test
3:31 Install dot projector flex to Face ID flex
3:51 Fasten Face ID flex
4:04 Face ID set up
4:11 Face ID works
4:21 Conclusion
JC-V1S Multifunction Programmer with True tone detection board ONLY for iPhone 8-11 Pro Max:
Dot Matrix Testing Board for JC-V1S Programmer:
https://www.elekworld.com/shop/productinfo.aspx?proid=13658&categoryid=289
JC Dot Matrix Flex: http://www.elekworld.com/shop/productlist.aspx?key=JC
Hot Air Gun: http://www.elekworld.com/shop/productinfo.aspx?proid=6351&categoryid=371e
Ecooper 3D Screwdriver: https://www.elekworld.com/shop/productinfo.aspx?proid=12338&categoryid=542
Soldering Iron: https://www.elekworld.com/shop/productinfo.aspx?proid=10031&categoryid=283
Tin Wire: https://www.elekworld.com/shop/productinfo.aspx?proid=6962&categoryid=283
For more Repair parts&Tools and Tech support, please visit:
Website: https://www.elekworld.com
Instagram: https://www.instagram.com/elekworld/
Twitter: https://twitter.com/ElekworldL?lang=en